Maxtor 98196H8 Specifications download pdf (Page 55)

INTERFACE COMMANDS

7 – 14

Seek, Format and Diagnostic CommandsSeek, Format and Diagnostic Commands

Seek, Format and Diagnostic Commands

SeekSeek

Seek

Initiates a seek to the track, and selects the head specified in the Command block.

1. Sets BSY in the Status register,

2. Initiates the Seek,

3. Resets BSY and

4. Generates an interrupt.

The drive does not wait for the seek to complete before returning the interrupt. If a new command is issued

to a drive during the execution of a Seek command, the drive will wait (with BSY active) for the Seek to

complete before executing the new command.

Format TrackFormat Track

Format Track

Formats the track specified in the Command Block. Shortly after the Command register is written, the drive

sets the bit, and waits for the host to fill the sector buffer with the interleave table. When the buffer is full,

the drive resets DRQ, sets BSY and begins command execution. If the drive is not already on the desired

track, an implied seek is performed. Once at the desired track the data fields are written with all zeroes.

Execute Drive DiagnosticExecute Drive Diagnostic

Execute Drive Diagnostic

Commands the drive to implement the internal diagnostic tests. (These tests are executed only upon

command receipt; they do not run automatically at power up or after a reset.)

The drive sets BSY immediately upon receiving this command. The following table presents the codes and

their descriptions. Note that the value in the Error register should be viewed as a unique 8 bit Code.

ERROR CODE DESCRIPTION

01 No error detected

00 Master drive failed

80, 82 Master and slave drives failed

81 Slave drive failed

Note: If a slave drive fails diagnostics, the master drive OR’s 80h with its own status, and loads that code

into the Error register. If a slave drive passes diagnostics (or a slave is absent), the master drive OR’s 00

with its own status and loads that code into the Error register.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 63 64

No comments

Maxtor 98196H8 Specifications Page 55